Step 3

Set up display

Put on your helmet as usual. Attach the head-up display to the helmet adapter using the magnets and fold the display down at a 45° angle. The display should now be clearly visible in front of your right eye.

Set the display correctly

Press the operating button on the Head-Up Display module to switch the device on. A message appears on the display.

Check that you can see the entire display clearly without changing the position of the helmet on your head. To do this, look forwards as you would in traffic. If the display is blurred or not easy to read, you can slightly change the angle of the display.

Readjust Sugru

If the frame shown on the display is completely or partially outside your field of vision, remove the Head-Up Display from the helmet and move the helmet adapter slightly in the desired direction.

Adjust the position of the helmet adapter until all the conditions listed here are met.

Remodel Sugru if necessary

Remove any swollen Sugru from the edges of the helmet adapter. Use a flat object for this, for example a plastic card or a popsicle stick. Make sure that you do not change the position of the helmet adapter.

Allow the layer of Sugru to harden completely before using the device. The curing time is 12 to 24 hours, depending on the thickness of the layer of Sugru. A layer of 1.5 mm takes approx. 12 hours, a layer of 3 mm takes approx. 24 hours.

Done!

You have successfully installed the helmet adapter in your helmet. You will now be guided through the next steps in your app.